Standard Features :
Self-Canceling Turn Signals
8-Position Tilt
4-Way Flashers
Knobs and Handles
Ford Turn Signal Switch
Ford Top Shaft
Floor Mount included
3/4" 36 Lower Shaft
Available Finishes: Paintable Steel, Chrome Plated Steel, Black Powder Coat
Steering Wheel Bolt Patterns Avialable: Ford Top Spline
Note: A stock Ford wheel will bolt on the top of an ididit steering column.
Recommended Accessories
Installation Kit
Part numbers

1965-66 Mustang Paintable Steel
Tilt Floor Shift - 1120642010

Part numbers

Note: A stock Ford wheel will bolt to the top of an ididit column.
An aftermarket wheel is required.

Add the convenience and reliability of a new column built specific for your classic Mustang. This steering column is not a universal column. Simply remove your old column, saving your original under-dash mount as well as the original floor mount. Using one of our installation kits (see table below), install your new steering column in place of the old. Add an aftermarket wheel and the gripping surface of the new wheel will be in the same location as the original.

Part numbers...

Note:
A stock Ford wheel will not bolt on the top of an ididit steering column.

Part # 3000313449

1964-66: Your original column has a solid shaft from inside the gearbox to the steering wheel. This shaft will need to be modified. A new coupler will need to be put in place between the modified shaft and the column.
Turn Signal Wiring: Your ididit column will come complete with a 3 7/8” GM plug. The female side to the plug is also included with your column. Simply crimp the clips to the end of each wire from your vehicle. Using the schematic provided match the function of the wires to those on the car.
Horn Wiring: Ford horn systems use two wires and 12 volts of power to control the horn function. ididit uses a ground type system through a relay. A relay is provided with your kit to successfully complete the conversion from the Ford system to the ididit system.

The '64 1/2-66's Installation Kit Includes:
Coupler Only
(Installation Kits are sold separately) .

Modified Shaft: The shaft will need to be cut and modified as shown above.