1969 Camaro Tilt Column Shift with Keyed Ignition - Paintable Steel
This retrofit column is designed to fit your Camaro or Firebird and does NOT require modification to your original vehicle to install. Simply remove your old column, saving your original under dash mount and floor mount. Using an ididit installation kit (see below), install your new steering column in place of the old. These columns come complete with a neutral safety switch (shift indicator not included). The shift pattern on the column allows you to use either a 3 or 4-speed automatic transmission. A shift linkage (new or original) is required for installation and will attach to the lower shift arm provided on the column. Using an adaptor, add an aftermarket wheel and the gripping surface of the new wheel will be in the same location as the original. Or bolt your stock 1969 Camaro steering wheel directly to your ididit column. Each column comes complete with a wiring harness adaptor.
A rag joint is a vibration reducer used between your column and gearbox. In some vehicles, the original rag joint is pressed onto the lower shaft of the column. If your rag joint has a pressed fit, it will need to be replaced. If your rag joint is removable, the original may be used. Please consider however that due to age, the original rag joint may be worn so please double check to make sure it is in good working condition. ididit, inc. always recommends replacing the rag joint.
Manual Gearbox: 3/4"-30
Includes 3/4"-36 x 3/4"-30 Rag Joint
Manual Gearbox: 3/4"-36
Includes 3/4"-36 x 3/4"-36 Rag Joint
Power Gearbox: 13/16"-36
Includes 3/4"-36 x 13/16"-36 Rag Joint
- Item Requires Shipping